New repair kit for your TD124 MkI and MkII main bearing.
Including the new improved brass/bronze end cap.
Please note the difference between the improved and the original end cap, as shown in picture 4.
Complete repair kit, as shown in the pictures. (the shown main bearing is not included)
Freshly revised main bearing for TD124 MkI and MkII versions. This bearing is in near mint condition.
The original sintered bronze bushings as well as the bearing spindle are showing no signs of wear, the bearing play is absolutely perfect. Original bearings in this condition are next to impossible to find.
It comes with our improved brass/bronze end cap, new gasket, new thrust plate, a set of new screws and the matching oil
2 sintered bronze bushings for TD124 main bearing. Outside diameter 18mm.
Perfect replacement for worn out or damged bushings. Will fit TD124 MkI and MkII versions.
Important; some very early MkI versions with nylon bushings are using a different outside diameter. Please check your bushings before buying
Dryed out and worn out idler wheel bushings are often the source of annoying noise. Our new sitered bronze bushing is an exact reproduction of the original and comes with a new NOS nylon washer.
Will fit TD121, 124, 135, 184, 224
For TD124, 134, 135, 184 and 224
Worn out bearings are often the source for annoying noise which is transmitted to the chassis.
Replacing these parts by our sintered bronze bearings fixes the problem.
Our kit also includes the matching thrust plate.
Exact reproduction of the original CB 965 rubber belt.
This belt will also fit the following models: TD121, 134, 135, 184 and 224
Please make sure to clean your motor pulley as well as the step pulley before installing the new belt.
Exact reproduction of the original rubber belt.
This belt will also fit the following models:
TD105, 110, 115, 125, 126, 127, 145, 146, 147, 150, 160, 165, 166, 226, 240, 280 MkI+MkII, 316, 318, 321, 325, 520, 521, 2001, 3001
Please make sure to clean your motor pulley etc. before installing the new belt.
Non-magnetic original Thorens platter. Essential when heavy MC cartridges like Ortofon SPU etc. are used and magnetical attraction is unwanted.
Used part in very good condition.
This platter comes with the original adaptor and all necessary screws.
RARE and hard to find item, only one available !
These 3 fasteners replace the hard to find original fastener part (picture 3)
We're adding a piece of sealant to help centering the screws
Next to impossible to do the job without the sealant
Set consists of 3 fasteners, 3 screws and sealant
Fits TD124 MkI and MkII
Extremely rare and often missing NOS spare part
Protects the stepped wheel spindle against dust etc.
Fits early MkI versions of TD124, 135 and 184